Thanks, that sort of got me going in the right direction. Still playing with it, but that got it working so far. Just need to tune it. Still having some issues getting it working right, but that'll be something I can hopefully work on myself?! ![:D]( "Big Grin")
Trouble I have is knowing what is needed and where! Believe me, I tried every combination I could think of, spent around 12 hours trying all sorts of different codes and researching what the correct syntax is, yes, I know it's in the manual, but it just wouldn't work. No doubt my fault, but when you don't know what you're doing wrong, you can't fix it in any other way than trial and error!![:-(]( "Sad")
I also didn't know I needed /Stdout. Didn't know what it was despite reading descriptions, as the descriptions are for those who know already what they are doing.![:rofl:]( "ROFL")
Ok, I'll try that site for RegEx, I did quite like the one I looked at as it explained in simple terms what each symbol does.
One of the issues I have is that the StringAlign is set to CenterCenter, yet when the RunCommand is activated and sets the Meters to show the value, the StringAlign seems to set itself to just Center, would you know why? If not I'll change it, no biggie!![:thumbup:]( "Thumbs Up")
So I have to use one command per Run Measure? Ok, I thought you could do two at once, but I think I read that it has to be separated by a ; which then comments out the line.
Trouble I have is knowing what is needed and where! Believe me, I tried every combination I could think of, spent around 12 hours trying all sorts of different codes and researching what the correct syntax is, yes, I know it's in the manual, but it just wouldn't work. No doubt my fault, but when you don't know what you're doing wrong, you can't fix it in any other way than trial and error!
I also didn't know I needed /Stdout. Didn't know what it was despite reading descriptions, as the descriptions are for those who know already what they are doing.
Ok, I'll try that site for RegEx, I did quite like the one I looked at as it explained in simple terms what each symbol does.
One of the issues I have is that the StringAlign is set to CenterCenter, yet when the RunCommand is activated and sets the Meters to show the value, the StringAlign seems to set itself to just Center, would you know why? If not I'll change it, no biggie!
So I have to use one command per Run Measure? Ok, I thought you could do two at once, but I think I read that it has to be separated by a ; which then comments out the line.
Statistics: Posted by sl23 — Yesterday, 9:50 pm